scrcpy 192.168.1.42:41234 37123 6 digits On the target: Settings > Developer options > Wireless debugging Device address The “IP address & Port” on the Wireless debugging screen Pairing port and code From the “Pair device with pairing code” dialog. Same IP, different port Enter the device address as 192.168.1.42:41234 Pairing port must be a number from 1 to 65535 Enter the 6-digit pairing code This target is not paired. Pair it again from the device list. The paired-device list could not be read; it was left unchanged. Use only on a network you trust, or over a VPN. ADB cannot verify the target\'s identity, so anything answering this address could receive what you type. Pair and save Pair a device Saved devices Mirroring active Settings Open-source licenses Notices unavailable. Video codec Audio codec H.264 (default) H.265 AV1 (target Android 14+) Raw PCM (1.5 Mbps) Opus (~128 kbps, default) Forget device? Max size (long edge, px) Original 480 720 1080 (default) 1440 2160 Video bit rate 1 Mbps 2 Mbps 4 Mbps (default) 8 Mbps 16 Mbps Max fps Unlimited (default) 30 60 90 120 Reconnect Back Home Recents connecting… disconnected Session error: %1$s The old session did not stop. Reconnect was cancelled. Back goes to the target. Press Back twice to leave. Home and Recents are in the bar above. Pairing… Changes apply on the next connection. Display Sync clipboard with the target Show status bar (IP and resolution) while mirroring No devices paired yet - fill the fields above and tap Pair.